Summary

There is a small connector piece between the servo connector in the fuselage and the rod that turns the aileron in the wing. I lost one of these and so printed this. I flew today and it performed well.

Print Settings

Printer:

Wanhao D6

                                            <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>Doesn't Matter</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>.13</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>100%</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>i printed with both PLA+ and HDGlass.  I flew today with the PLA+ version although I think the HDGlass printed a bit better.  There is some vertical cracking which I will seal with glue - at the corners of the center square.  This was not enough, however, to cause the part to break under stress.</p></div>

How I Designed This

Fusion 360

Zohd Orbit Aileron Tab