Silica Desiccant Absorber Box

Just a simple box with a bunch of cutouts to allow for moisture to be absorbed without allowing for the silica desiccant to able to fall out through the holes.

In my initial print, i found that the lid was a bit too tight, however this was printed at 40mm in size. I shall test with a further print at 60mm (current default in the STL file) and check results again.

If you print one of these out, be sure to report back the results for everyone!

Jan 1st 2022 Update:

I've scaled the lid in the v1.1 STL (and the f3d source) to 0.995 as suggested by one commenter.

This is by far the most downloaded design i've made - not sure why, but i'm glad it's getting some use. I'd suggest using the newer files from now on, but i'm leaving the older files there in case others want to use it.