Summary

C87 - servo saver part 3

This steering part is for the ACME Raptor Truggy.

Instructions

For the servo saver which easily broke down are two models.

Original, but is two weak when printed
Modified stronger version which works great.

Printsettings:
The mod version can be printed without raft and supports if the flat side is under and gives the best result.
100% fill with 2 shells and layerheigtht not to low, choose 0.2 or higher.

After printing the holes must be drilled with:

big hole with 4.0mm
mid hole with 3.5mm
small new hole 2.5mm
Assembling the axle with some grease for low resistance.

ACME Truggy saver