Oculus Touch PVC adapter for Beat Saber

This is a remix of GrooveDachschund's model. I thickened a very thin wall near the top, fixed the grip button cutout, and made the bottom hole larger so the wrist strap's plastic nub can fit through too. I also made the base diameter a bit smaller, so I wouldn't need to sand it down to fit. This is just a model for the right-hand controller, flip it along either the x or y-axis in your slicer for the other side.

I used (for both controllers):
2x #6-32 machine screws, 3/4" long
2x #6-32 wing nuts
4x #6-32 washers
some length of Schedule 40 1" PVC, I used about 8" per handle
a couple 1" PVC endcaps, if you're feeling nasty

PLEASE NOTE! I am going to use an epoxy to bind the print to the PVC pipe permanently, so I am not worried about the print being tight enough to stay in on its own. I highly recommend the use of an adhesive for this project. Also, I offer no claim of liability for any damages that may result from the use of this model.

Update 6/08/2018: I put some grip tape on the PVC, and I couldn't be happier. see final photo.