X-ends for holding 20x20 extrusion bushings/nuts

As seen here: (well almost, this version takes bushings instead of lm8uus)
https://www.youtube.com/watch?v=7Cn1s9_PII0

These x-ends are compatible with a simple Z-Nut or dual Z-nut with spring pair - should fit M8 or similar, I'm using it on acme 1/4" rods in the video.

These x-ends don't hold x-rods, they hold a single 20x20 extrusion.

both ends have an integrated bolt holder meant to interface with a z-endstop held in the lower part from thingiverse.com/thing:28425

By the way these are intended to use a pair of 605zz bearings for the idler. You'll have to enlarge the hole either before or after printing if you intend to use 608zzs.