Summary

Spoke magnet holder for 8x3mm round magnet.

M3 screws 5 to 10mm should fit.

Print Settings

Printer:

I3 Mega

                                            <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>Doesn't Matter</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.1</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>10</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Printed at 108% in Cura worked best.<br>you should use a brim.</p></div>

Post-Printing

install on spoke

            <div><p>hotglue the magnet in.<br>heat the spoke up a little with a lighter then tighten the screws.<br>Tapping the hole may be necessary.</p></div>

Spoke magnet holder small