Sensor base for five PCB 208C01 force sensors for toe pressing experiments

This is a base for five PCB 208C01 piezoelectric force sensors. It is designed to be used in toe pressing experiments. The force sensors are attached using slotted flat-head #10-32 screws, 3/8`` long. The board should then be attached to a wooden board, also using #10-32 screws (but with socket caps), with an appropriate length (depending on the thickness of the wooden board).

The appropriate size should be selected to match as close as possible the width of the foot of the participant, you can slide the sensors forward / back as necessary to match the toe pad locations. The same piece can be used for left or right foot by rotating it 180 degrees. The spacing of the sensors has been selected to fit most foot sizes.