Manípulo Eneágono ( Knob )

Trabalho de cunho acadêmico para a disciplina Design do Cotidiano, onde optou-se por uma peça para compor uma aplicação em um mobiliário de uso comum e diário.

O projeto consistiu em desenvolver e imprimir um manípulo que será usado como trava de posicionamento para uma mini poltrona. A parte de maior complexidade da peça seria a inclusão de uma porca sextavada em seu centro que ficaria coberta por mais algumas camadas de filamento.

Com o trabalho de impressão iniciado, aguardou-se até o ponto exato para pausar a impressora, subir o bico extrusor e então delicadamente embutir a peça no centro da primeira parte impressa. Continuando será possível observar que a impressão da "bridge" que cairá por cima da porca sextavada tenderá a ficar um pouco saliente pois a material não adere no metal, porém já na próxima camada o problema é resolvido.

OBS.: Porca sextavada para uso interno com diâmetro de 12mm e altura de 10mm.

Academic work for the Design of Daily Life discipline, where a piece was chosen to compose an application in a common everyday furniture.

The project consisted of developing and printing a handle that will be used as a positioning lock for a mini armchair. The part of greater complexity of the piece would be the inclusion of a hexagonal nut in its center that would be covered by some more layers of filament.

With the print job started, it waited until the exact point to pause the printer, raise the extruder nozzle, and then gently inlay the part in the center of the first printed part. Continuing it will be possible to observe that the impression of the bridge that will fall over the hex nut will tend to become a little salient because the material does not adhere to the metal, but already in the next layer the problem is solved.

NOTE: Hexagon nut for internal use with a diameter of 12mm and a height of 10mm.