Odroid C2/C1+ Case (60mm cooling fan)

Another Odroid Case I made. Should also fit a C1+
This one is for a 60mm cooling fan that's 11mm thick.
It requires 4 small screws -> 2.5mm diameter, 4-6mm long screws with maximum 5.2mm diameter head.

The other case I made was too large and bulky, and with an open funnel that sucked in air and dust, I wanted to fix that.

I didn't want the fan face down on the heatsink because it would just suck in dust from the top on to the board.
I designed it so that it draws air from one side to the other (without it being too tall).

Included in the files is the 60mm fan and a mock-up of the Odroid C2 for anyone wanting to use it to make their own version.

---- Settings -----
I printed at 0.2mm layer height.

Base.stl
Support infill percentage: 100%
Horizontal offset from part: 0.5mm

^^^^ use those settings to make removing the support structures easier on the Base.stl file.

Doge donations: D5cqNG1nHCRWeyFHv5LaJNrMP54MVyM2Az
Much appreciated!