Fin Glue JIG 3/32" model rocket

You can use this tool to accurately align fins, and hold them in a proper place while the glue dries. You can also use one side as an tube alignment mark extender . To use it, just hold it in place on your body tube using painters tape or a rubber band. It can be used for most standard body tube sizes . This can be used to hold fins in a wide variety of configurations , 1,3,4,or however many fins you can fit on a body tube. This is a jig that I created many times from woodworking tools, However I can make it with far greater ease and less materials when I print it. The offset for the fin on this jig is a 3/32" fin, arguably the most common thickness used by low power Rocketeers. If there is more interest, I will also add additional offseted jigs to this thing page.

Please take the time and check out my other model rocket things.
https://www.thingiverse.com/thing:2845691
https://www.thingiverse.com/thing:2847499
https://www.thingiverse.com/thing:2854187
https://www.thingiverse.com/thing:2854204
https://www.thingiverse.com/thing:2854660
https://www.thingiverse.com/thing:2856923
https://www.thingiverse.com/thing:2859568
https://www.thingiverse.com/thing:2872159
https://www.thingiverse.com/thing:2876174
https://www.thingiverse.com/thing:2881947
https://www.thingiverse.com/thing:2941984
https://www.thingiverse.com/thing:2944705
https://www.thingiverse.com/thing:2958861
https://www.thingiverse.com/thing:2978513
https://www.thingiverse.com/thing:2985524
https://www.thingiverse.com/thing:3015692
https://www.thingiverse.com/thing:3015754