FLIR Ex 20mm Lens Holder

This is a lens holder for the FLIR Ex cameras, it holds a 20mm lens snugly and fits snugly into the camera. I made this because the other one available is quite bulky and a little temperamental to get the angle to print clean. This one prints in about 4 minutes by itself but I recommend printing at least 3 at a time to allow cooling.

These are setup for a .35mm nozzle which will produce 2 perimeters through the entire print. I have infill set to 100% as well as concentric infill but it may not be needed at this point because I trimmed it down to force 2 perimeters.

This one is small enough that the camera is almost fully unobstructed except for a little fuzziness at the bottom.