Summary

deleted

Print Settings

Printer:

Anet AM8

                                            <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.2</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>20%</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Printed in PLA and PETG.<br>I prefer PETG, because it's softer so the stacking is more comfortable.</p><p>Supports needed for all three files.</p></div>

Post-Printing

If you have a chunky Z-seam you should sand it or cut it down.
It might cause the parts not to fit propperly and/or makes it harder to seperate them.

Same thing if the parts have an "elefant foot" (caused by printing very close to the bed).
Cut it away or sand it to make the parts fit properly.

If the parts are stuck together, simultaneously pull and screw them (don't bend) - this will loosen them. They fit better the more you play with them.

to delete 3