Printerbot Jr. V2 DUAL Bowden adapter plate V1.0 (EXPERIMENTAL)

So I asked myself why I couldn't find a bowden adapter for the Jr. V2... for some reason the printrbot community on thingiverse is obsessed with mostly the plus and simple... anyway I did my research and a drew one up... Then I made it dual :P

Disclaimer, I haven't tried it yet, still getting the tube and other hardware. if you have a problem tell me

intended to work in conjunction with this cable coupling: http://www.thingiverse.com/thing:1899 READ INSTRUCTIONS to figure out how to resize it.

IMPORTANT - POSITION SPECS:

• one extruder is 10mm towards the rear of the printer from the original position
• the other extruder is 20mm out towards the front of the printer
• they are 30mm apart (if you hadn't figured that out yet)

***I know nothing about hole sizes... I just assumed M3 bolts and I made tight holes 2.3mm and loose holes 2.5mm if anyone has any knowledge about that or suggestions let me know, thanks

Up next.... fan adapters for 40mm and 60mm fans