Summary

This is the lid for the Arduino Enclosure thing.

When was 3D printed it was necessary to multiply the dimensions x1000 as it was originally CADed up in millimeters and when it was exported to an .stl file the units were changed to meters.

Instructions

This lid slides into the Arduino Enclosure (see other thing titled: Arduino Enclosure, Rev#).

Note:
When was 3D printed it was necessary to multiply the dimensions x1000 as it was originally CADed up in millimeters and when it was exported to an .stl file the units were changed to meters.

I referenced schematics by johngineer found here:
adafruit.com/blog/2011/02/28/arduino-hole-dimensions-drawing/

and schematics by Wayne and Layne found here:
wayneandlayne.com/blog/2010/12/19/nice-drawings-of-the-arduino-uno-and-mega-2560/

in the design of this thing.

Whim
imaginen4tion.com

Arduino Enclosure Lid, Rev1 (mm)