Tevo Tornado Spool Holder

On my Monoprice Select Mini V2 I use the spool holder designed by jasonjones (check the source) and I really like it. So I remixed (Tinkercad) the arms and the spindle to fit the Tornado or any 20x20 frame. It goes on the top left.

You need to print:
1x left arm
1x right arm
1x spindle
2x spacers which will feet your filament spool. I remixed one spacer of jasonjones for the 3DPrintingCanada Value PLA. You can find others in thingiverse (Hatchbox, AMZ3D ...) or check the ones by jasonjames and modify one. I printed 4 of this. On one of the spool it fits really tight on both side and on the other filament (also Value PLA) one side is tight, the other one is loose. You can use teflon tape to resolve this.

To install this, you will need:
4x M5 t-nut
4x M5x12 mm screw

Print Settings:
Layer Height: 0.3 mm
Infill: 60% (a bit overkill but it was my 3rd prototype so I played it safe). Try it at 20% and tell me if that's enough, it should be.
Speed: 40 mm/s
Support: Yes
Time: About 4h for the 2 arms and the spindle