Summary

This is a small vent i made for my Terrarium. Added a small support in the middle so the "fins" are stronger.

15cm wide and 8cm tall.

Printed with no support.
15-20% infill
speed i used was 40ms

Printed on Anycubic linear plus.

Print Settings

Printer Brand:

Deltaprintr

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>Deltaprintr Kit</p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.2</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>15-20%</p></div></p>                                                    <strong>Filament:</strong> Esun  Pla+                Green

Small Vent