Summary

Motley patterned 25 mm bases. Files include versions with slots for a 10 mm by 2 mm or an 8 mm by 2 mm magnet.

Print Settings

Printer Brand:

Monoprice

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>Select Mini</p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>25%</p></div></p>

Post-Printing

Sand down the vertical face; you may need to focus on the bottom edge. Use a hobby knife to clean up any print imperfections in the surface pattern.

If you are using a magnet, insert it into the slot, and push it into the space in the center. It should drop into position. Secure the magnet with glue (CA or white glue work well). If you want to seal the slot, you can use green stuff. Paint as desired. Note that if you are going to pin your figure to the base, you can't drill down the middle because of the magnet, so plan your pins accordingly.

25 mm motley base