MHQ Omni Vibe 7mm

Smaller print bed, slightly wider, and angled isolator holes.

This uses the Hovership MHQ arms.

Current setup:
4- Sunnysky x2208 2600kv
4- 20A Slim Afro ESC
1- MultiWii Pro EZ3.0
1- BT module
1- Frsky v8fr-ii HV
8- 37mm standoffs (will be changed to 1.5" later)
4- HQ 5030 props
1-Turnigy Nanotech 3300mah 3S LiPO

VTX/Camera/MinimOSD this weekend

890g AUW

Update V 0.3
-CAUTION If you fly with a heavy battery on the top plate and you go into an auto-level mode your moment of inertia delta between your clean and dirty plate will result in an unstable system and you will crash. I learned this the hard way...nothing broke though!

-FIXED All hardware holes are slightly larger for easier assembly
-FIXED Protruded the vibe isolation settings to give better print quality.

-NEW 45x45 FC can now be suspended from top plate.
-NEW Battery can be suspended from bottom plate as well as set on top plate.
-NEW Added landing gear
-NEW FC Plate extended to give more real-estate to mount stuff
-NEW Integrated top plate and cam holder. Also, added a VTX mount on rear.

Update V 0.2
-FIXED Standoffs prevented mounting of Naze32
-FIXED Power Distro Board was too snug (make a little wider)
-FIXED Reduced number of holes on Bat Plate

-NEW Camera Holder

Update V 0.1
-NEW FC Plate
-NEW Batt Plate