Summary

This is a clip that was designed by my friend by Dumle29 with the dimensions fixed by me.

PLEASE see the Instruction tab for instructions on how to use. And PLEASE READ ALL THE INSTRUCTIONS BEFORE ASSEMBLING.

If you have any comments or concerns you can reach me through the comments here or send me a message on my thinigiverse profile.

Instructions

Print 3 of these out, remove your MDF board/heated bed from your Kossel, flip it over and tape or hold your PSU to the MDF board while you make markings for the clips.

Position one clip on one side of the PSU and the other two on the other, and mark the holes to be drilled with a pencil. REMEMBER: MARK TWICE, DRILL ONCE. It's really easy to mess up with MDF board since it's so soft. You can drill the holes out with a 7/64" drill bit if you want a snug fit or a 1/8" bit if you don't want to thread the screws into the board.

After you have the 6 holes drilled, flip the board over to the side that would normally be up and use a drill bit that is the size of the M3 bolts' heads. AGAIN, BE VERY CAREFUL, just tap the trigger on the drill, you just want enough to recess the head of the M3 screw, but if the drill grabs the board hard enough it will go all the way through. If you have a drill press that would work better.

From there it's just putting M3 bolts through the board and into nuts that are recessed in the mounts. Nothing too hard.

Kossel Clear PSU mount for under MDF board