Fat Shark 600TVL Mount for Hovership

I couldn't find a good way to mount the 600TVL camera onto the quad with zip ties. This little mount does the trick. The screws on the back of the camera hold it in place.

Slight tweaking will likely be needed to get this to be a nice tight fit. It should go around the spacers fairly snug and top and bottom plate should hold it in place. My printer printed the inside too undersized so I opened it up with a 13/64 drill bit, this makes for a nice snug fit.

The mount is vertically offset as the camera will not (comfortably) fit between the top and bottom plates of the quad. Thus the camera is pushed out in front of the bottom plate and slightly down (0.5mm) to provide clearance for the top plate. It is easy to see when printed.

I printed with 2 perimeters at 80% fill with support. The yellow (lite version) was printed without supports. So depending on your machine you may be able to get by without supports.