Summary

K8200 snap on electronics enclosure with 80mm fan mounting.

Because bigger is better... isn't it? It's definitely quieter.

Instructions

0.3mm layers PLA

It warps off the bed nicely due to the small area and high walls. Print with at least a 3mm brim, pause after 3-4 layers and stick down the brim with tape. Do it like this:

pause
move the table out of the way. DO NOT use home axis.
attach tape quickly before the power to the motors is cut. If in doubt, command the table to move a little between applying pieces of tape. Make sure only to tape the brim, not the print area.
Make sure the tape is flat so the nozzle doesn't catch it on the way back to the print
wipe off any excess extrude that has oozed out fo the nozzle.
unpause and watch the show.

The thickness of the walls is designed to give an exact number of perimeters for a fast print. Change the extrude width value in the scad parameters to get your own fast print setup. 4 layers walls are ok. Default extrude width is setup for 0.51mm.

Printed at super speed using E3D hotend.
90mm/s perimeters
80mm/s outside perimeters
120mm/s infill
195C hotend, 60C bed
Print time 1hr30

K8200 Electronics cover with 80mm fan mounting