F-F-Fiddle Grover Remix

First, I am new to 3d printing, Fiddles, and fairly new to 3d modeling.

This is a remix of the Bout for the F-F-Fiddle by OpenFabPDX to use Grover Ukulele Tuners, specifically 9NB Sta-Tite Ukulele Tuners, Nickel with Black Buttons

They are on Amazon at this moment for $13.99 which brings the total cost of the fiddle down significantly.

They are shorter than the originals used so I had to make the body more narrow at this section. Because of this I printed at 30% infill cubic and have not had any issues yet.

I am fairly new to modeling so the topology is not as nice as the original in this section, however once you sand it down its unnoticeable for the most part.

All the wiring tubes are in tact and function but I did have to increase the angle of some of the bends which make it more difficult to push the wiring through.

This is my first Thing posted so please give me some feedback if I did something good or bad or whatever.

Thanks for checking it out!