Yung SD200 Amp Chassis

This is a multi part chassis for the Yung SD200 subwoofer amplifier.

Also requires M3 screws and M3 nuts to attach the amp to the chassis and the sides to each other.

Print two long sides, two short sides and five back pieces. The piece with terminal cutout would have to be trimmed down/might not fit work at all. Haven't tried it.

Mirroring is not necessary, I designed all critical parts symmetrically. You do need to drill holes for the mounting hardware, enough flexibility is designed in.

One thing that I'd change on revision is to make the countersink holes larger diameter, the cap head screws are slightly too big to be fully countersunk. Also, I'd size down the back panels a bit more, or size up the receiving slots. A bit of sanding took care of it though.