1/300 Flower-class Corvette

NOTE please use the flower-class version 2 stl file in future - the forcastle step and superstructure were positioned somewhat too far forward in the old version. I have left the old version here in case anyone needs it for any reason.

This is a WIP waterline-model Flower-class corvette for naval wargaming. Scale to 85.7% if you prefer 1/350, or 0.429 for 1/700 (some detail may not print at that scale, however-I haven't tested it). Be aware it is a little over 21cm long, so you may have to turn it diagonally for a 200x200mm print bed, or cut it into sections for a smaller one. It should print without supports, however. Use wire or plastic rod for the mast - a location hole is supplied just aft of the bridge.

A crude representation of the 4-in bow gun and 2-pdr pompom AA have now been included.
Print the guns with support, with the barrels facing vertically upwards.
It still needs considerable detailing and various smaller aa-guns (which will hopefully be added soon). Carley floats can be borrowed from my 1/100 1940-model vosper and scaled appropriately.