This is a Motorclip for mounting 8520 Motors to Microquads.

I didn't like the rubber grommets that came delivered with it, because i had to realign the motors after every flight.
This Clip does only fit Frames with a 11mm Hole. Better measure yours first. I stumbled upon a Frame with a much smaller Hole, where it dosn't fit at all.
You might as well just print it, it's not that much of PLA.

I might upload a smaller Version of the clip.

This clip is designed for Carbon Fiber Frames, with a small opening. I also added a second Version, for those frames that don't have that (see the Pictures for Clarification)

How to install:

Align one of the notches with the cutout of your frame, press down, turn by 180°, and press everything through. To lock, rotate by 90°
Its designed to be a little difficult, so it is hopefully very rigid.

It's my first custom designed and printed Part. I even did that in Tinkercad, because Fusion360 kept crashing.

Feel free to remix it.

How to print:

I printed mine in 0.12mm and it worked just fine. Infill doesn't matter, 'cause there is none :-)
Print Time: about 8 Minutes for each Mount.