General Description

This is a remix of the base made to fit an 140% scaled version of Wave lamp Yeah! I've added a curled spiral to hold a LED strip.

Requirements

• Print a 140% scaled version of the Wave lamp Yeah!
• Mount a WS2812 LED Strip (RGB or RGBW) onto the spiral of the base
• Get an USB cable to power the Lamp while using it
• Flash Software into a Wemos D1 mini

Hints

Length of the LED strip will be 54cm. Using a 30LED/m strip will work directly powered from the Wemos 5V pin without problems. That will use 18 LEDs.

Enhancements

The Wave lamp can be printed upside down in vase mode.
That will create a really thin surface which make the lamp brighter.

Files and Models

I've uploaded several different STL files to have to possibility to vary which type you like to use:

Yeah_LEDStrip_BaseOnly.stl

This is intended to be used if you like to have two separate parts. The base and the holder which can be optionally glued together. Might be useful if you use a lager ESP than WemosD1mini.

Yeah_LEDStrip_BaseOnly_VaseLamp.stl

If you pint the Yeah Lamp upside down in vase/spiral mode the inner wall of the lamp will not get printed. This cases the lamp to be like 2mm smaller in diameter. Use this base to make it fit to the lamp printed in vase mode.

Yeah_LEDStrip_HolderOnly.stl

This part can be used with both bases if you like to have two seperate parts.

Yeah_LEDStrip_BaseHolderSinglepart.stl

Version containing one single part to use a standard 140% version of the Yeah lamp not printed in vase/spiral mode.