Summary

I bet I am not the only one in this world who's cable for his Proxxon Minimot / Micromot drill broke. But as the original cable is cast into it's strain relief, you cannot simply replace it without leaving a big rectangular hole in the shell of your device.

Thus I created a snap-in strain relief and used a zip tie to fasten the cable to the relief inside the machine.

Good luck :-)

Print Settings

Printer:

Geeetech A10

                                            <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.15</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>20% Honeycomb</p></div></p>                                                    <strong>Filament:</strong> 3D FREUNDE PLA                grey                    <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Flip it to avoid supports O:-)</p></div>

Proxxon Minimot 40 Cable Strain Relief