Summary

This attatchment is intended to be used on a TBS Discovery or a Locust type frame and installed with two moon gel sheets and a "TBS Pro Gimbal Damper Upgrade" (http://team-blacksheep.com/products/product:253).
It is a gimbal mount that functions as a vibration damper. fits perfectly with the Gorpo gimbal brushless motors purchased on ebay.

Instructions

Made using Tinkercad. Moongel, In my opinion makes a better Damper then traditional rubber balls dampers. This desighn was created to exploit that fact.
Warning! You must cut out your own cable access for the brushless motor. In the pictures you can see I cut my own out using a rotary tool. But if you want, just put your own hole in the file before printing it out. The designer did not know where your cable access would need to be.

There are holes that are intended to be used as screw points for the attachment plates, but I just glued the plates on. Simply center the attachment plates, on the top and bottom plates of your quad. Then, insert the brushless motor into the damper unit (after cutting the cable access) and attach the TBS Pro Gimbal Damper Upgrade.
Remove the top or bottom plate of your quad and sandwich the damper unit between two moon-gel sheets, and place between the attachment plates and the top and bottom plate of your quad copter. Make sure to anchor the TBS Pro Gimbal Damper Upgrade at the appropriate point when all is done.

Front Mount Gimbal Damper