Summary

A wall mount for a Note 10.1 2014 in portrait orientation.

Print parts A + B twice, then screw the parts A to the surface. Distance to taste.
Slide the parts B on, don't forget to put the tablet in in-between.
Underlay a piece of cloth or something, there is a little gap between the table and the surface.

If the B parts don't slide on easy, trim the upper edges of part A a bit, otherwise you'll never get it apart again.

Print Settings

Printer Brand:

Ultimaker

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p><a rel="nofollow" href="https://ultimaker.com/" target="_blank">Ultimaker 3</a></p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>Doesn't Matter</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.1mm</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>50%</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Should print well without support in the original orientation. Less infill is probably ok as well.</p></div>

Wallmount for Note 10.1 2014