Summary

This is a simple holder for 2.54mm (=1inch) optical filters or lenses. The optical piece shall not be thicker than 1mm or so.

An example for a filter is included, but this is just for fit check, it is not a useful piece.

The retainer is keeps the optical piece in place. Print as many as you need.

In case you have a small printer, then use "Holder-A" and "Holder-B" and "Pin" and assemble the full filter holder afterwards. The fit migth be rather tight.

Print Settings

Printer Brand:

Wanhao

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>i3 Mini</p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.1mm layer height</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>20%</p></div></p>                                                    <strong>Filament:</strong> Rigid Ink PLA

Filter Holder (4 x 1")