Philips Fidelio L1 Earpad Adapter to Brainwavz

The non-replaceable earpads of my Philips Fidelio L1 headphones finally started to tear from use. I saw the earcups were held together using 4 screws, so I used those to add in this spacer which adds enough clearance to slide on a replacement pair of earpads (Brainwavz pads are high-enough quality and pretty easy to get through Amazon).

NOTES:

• I only modeled the right earpad, and then mirrored it in my slicer.

• The .STL has a sacrificial bridge through the counterbored hole to avoid using supports. You will need to clear this out using a ~7/64" drillbit.

• The section where the screw head bites down is very thin. Make sure you have good layer adhesion for the print, and try not to put too much load on the adapter. Once the earpads are on, it'll be a bit more protected, but still a bit fragile.