Donkey Car Mounting Frame

This model includes a frame to which a Raspberry Pi, servo controller and camera can be mounted to.

Includes mounting points for:

• Raspberry Pi Model 3B+
• Raspberry Camera Module V2
• Adafruit 16-Channel 12-bit PWM/Servo Driver (PCA9685)
  (or components with similar hole placement)

Designed for HSP 94186 Brushed RC Car with dimensions 175 x 25 between cover hole centers

Brief:

• Print volume: 190 x 84 x 25 (main frame) and 86 x 30 x 17 (camera arm).
• Maximum bridge is 26mm long (approx. 1 in)
• 1mm wall/three perimeters is sufficient
• No supports required
• 13 M2.5 x 8-10mm bolts, 13 nuts and 2 washers required (3mm ID x 8mm OD)

Advantages:

• Easy access to SD card from top, power ports from sides
• Camera arm pivot
• Little material required and fast printing time
• Extra batteries can be mounted on top of the main frame
• The main frame can be mounted upside down if the camera arm is not required

Disadvantages:

• Ensure your ribbon cable is long enough (standard Camera Module V2 is acceptable)
• Non-conductive spacer (sponge) required to reduce stress on PCB