Model Tank Track Jig

Model tank track assembly jig, print with minimum 15% infill or higher. There are 4 files, first one has all in a single print. The other 3 files are for separate prints.

Update: 10/21/19
Uploaded revised track jig, the pins are a little wider, screw is and nut is much better. This should be printed at 100% infill so the screw doesn't snap off.
Model Tank track assembly jig wide Base Plate Rev B.stl
Model Tank track assembly jig wide Knobby Nut for Rev B.stl
GOSM Tank track assembly jig wide Slide Plate Rev C.stl

Update: 10/16/19
I tried printing the bottom plate with bigger screw, wasn't successful. Going to need to revise that part.

Update: 10/13/19
Revised the base plate for Model Tank track assembly jig , apparently the bottom of the plate wasn't flat during the design. The new file is Rev D.

Also added a new base plate, this is the wider version, file name is Model Tank track assembly jig wide version

Update: 9/4/19
Uploaded a new version, with a bigger screw and nut, Revision C files

Update: 8/6/19
Revisions B has the thicker guide pins
Version 2 base plate uses a wing nut, washer and screw and the same slider plate

Update: 8/5/19
I will make the guide pins a little thicker later today. As they are a bit skinny