Summary

This is a phone stand adapted from Mike-vom-Mars. His was listed as a phone/tablet stand but my iPhone 6 is not wide enough to be supported by both the low extrusions. I thought about scaling it down but then the top of my phone wouldn't have adequate support. So a few hours of reverse engineering in Fusion 360 and here is my version. I made it so that minimal printed support is needed; however, I did print with supports because of the overhang on the Stand.

Print Settings

Printer Brand:

Prusa

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>I3 MK3S</p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.2 mm</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>20%</p></div></p>                                                    <strong>Filament:</strong> Prusament PLA                Silver                    <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>I printed with 0.2mm layer height on a Prusa MK3S with standard 0.4mm nozzle. Sliced in Cura with tree supports to support the overhangs on the Stand part.</p></div>

Post-Printing

Post Print Processing

            <div><p>I printed with a brim to increase bed adhesion. I also used tree supports in Cura because, well, they're like magic.</p><ol><li><p>To start, use pliers and a razor blade to remove the supports and brim and do some general cleanup and sanding. </p></li><li><p>Then, mate the rounded extrusions on the inner bars of the Stand to the holes in the Base in the correct orientation. This may take some force (or more sanding). </p></li><li><p>Similarly, mate the rounded extrusions on the outside of the Stand to the BackBar (any orientation will work).</p></li><li>Watch your favorite episode of Rick and Morty on your phone (in Landscape mode) on your brand new phone stand.  </li></ol></div>

Foldable Phone Stand