Summary

This is a desk holder for the controller clam grips, (also works for controllers without the grips).

If people want one without the 'ears' so that you don't need to print with support or just aesthetically then let me know and I will upload a new version.

Print Settings

Printer Brand:

Creality

                                            <p class="detail-setting printer"><strong>Printer: </strong>                     <div><p>CR-10</p></div></p>                                                                                <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.2</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>10~15</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Print on the side and use support so that the 'ears' will print properly.</p><p>I print these rough and ready and they come out fine for me. Pretty easy print. </p></div>

Post-Printing

Remove Support

            <div><p>The support I had on was probably a little too much. Philbarrenger's clamp (the thread will print without. The 'ears' are the only part that needs the support to print.</p></div>

Desk Clamp Xbox Controller Holder