Ultimaker 1 E3D v6 Bowden mount

E3D-V6 mount for the Ultimaker 1
--
is remixed from Musti's E3D mount.(http://www.thingiverse.com/thing:145988)
The interior, which holds the E3D (E3D-v6) all metal heatsink bowden edition, is redesigned for the v6 version.
Just order from E3D online:

• v6 Heatsink 3mm bowden
• v6 heat sink break 3mm
• 30x30x10mm DC fan
  Then print the parts and you are good to go. I used the original UM1 heater block, extruder nozzle and thermocouple and printed these parts in ABS.
  Also printed the fan-duct from Musti, which I had to remix slightly post print using a set of pliers to cut away some plastic so the original UM1 heater block does't touch the fan duct. (Too impatient to redesign the fan-duct for this setup :-))
  If you need it and are not in the position to print, you can find it online at our website! (Dutch, willing to ship outside NL)
  ............
  Update:
  ............
  Although my version 2 was working great, I am working on a version 3, which has:
• the top of the E3D-V6 better aligned to improve the bowden clip mounting
• enable slightly better cooling of the E3D-V6 heatsink
• an additional mounting area at the bottom for the original thermo couple amplifier PCB so your build plate is beautifully lightened by the blue led from the amplifier.