Orange Pi PC2 case

Credit to powermos

Original files were updated to expose USART header, give better access to GPIO header, and allow for display connector lead to be threaded out of the enclosure.

The screw and nut holes were enlarged, some cutout sizes and position adjustments were made to better fit the Orange Pi PC2 board (my own at least) and vent holes were added on the sides.

Notes:
Printed on Anet A6, 0.4mm nozzle 0.2mm layer.

Support is needed for one of the corners of top lid, the vent arches have a single line support "built-in" that easily breaks off.
My printout is 3 bottom and 4 top solid layers with 30% infill in between to save time, so especially the top part feels bit too flexible/fragile on its own but it seems fine when screwed together.