Summary

Holder for 2x 10mm LEDs to mount externally on your rig, used to show GPS/ARM Status

Instructions

Parts Needed

2 x 10mm LED's
2 x 100ohm Resistors
2 x Servo connectors

Instructions
Attach the Led Cathode to the servo connector ground.
Attach 100ohm resistor between the signal on the servo connector and Led Anode
Mount in Led Holder with some hot glue or CA
Mount on your Rig where desired

Connect to ArduPilot on channels A7 and A6
In Mission Planner Set LED_MODE = 3 (this sets GPS/ARM status on ports A7/A6)

enjoy.

ArduCopter External Status Led Holder