Summary

To celebrate womanhood, pregnancy and motherhood, presenting a two-piece stylized representation of a pregnant woman, suitable for use as a pendant.

Instructions

Load and print, at least 10% fill. To reduce terracing, use the lowest layer height or treat after print. I used 0.2mm and 0.3mm for speed of printing.
The difference in the four "belly" models is the sizing of the aperture for fitting onto the woman. The v2.2 should work, but I've found that the opening is often under-sized. v2.2a is the largest (120% of the size) with v2.2b being in-between (112% of the size). Both the "a" and "b" versions worked in test prints, but the "a" was a looser fit. To be sure of fits just print the "a" version and just a bit of superglue to ensure it stays in place.
If the whole piece is to be a single color then use http://www.thingiverse.com/thing:387079 instead, though for mix-and-match printing both pieces in one color, reloading filament and printing both pieces again saves on swaps.

Pregnant Woman Pendant, Separate Belly