Summary

Hi, this is my first upload, I have received as christmass gift wind chime square, but no spinner were included. I have checked web and there are few between 15-20USD, it seemed too much for me, so i have created first draft prototype in 10minutes with stuff which i have had on my desk (1,5V batery, few wires, plastic stripes, few safety pins and very old cd-rom)
http://www.youtube.com/watch?v=7RvLLuwNciM&feature=youtu.be

Instructions

Take old cdrom, open it, remove some engine from it (I used the one for cdrom opening), solder out conector to which engine were connected, take wires, solder 2 wires to removed connector and other ends to 1,5V batery, put some safety pins around plastic on the engine end (it was used for rubber circle), i put to it safety pins to have something to which i can put plastic stripes, use 2 plastic stripes around engine to which you will use something on which engine will hang on, put 1 plastic stripe around batery and to it connect one more to hang it (1 is for hanging, 1 is for second plastic strip to not slip). Check attached pictures. When you hang it on, try to get engine hangers (in my case small rope from spool) closer together, it will reduce swing when plastic rope from wind chime start to make resistance when it is twisted. With few junk stuff and small amount of time you can make something usefull :)
http://www.youtube.com/watch?v=7RvLLuwNciM&feature=youtu.be

Wind Chime spinner