Fan shroud for Hexagon hotend on Type A Machines Series 1

I ordered a hexagon hotend kit that came with a shroud---the design was screwy and it fit poorly and easily rested on top of the heater block. This one is made to slide between the bottom-most fins and and has additional wings to slide in between some upper ones. Fits nice, looks good, stays cool. I probably could have done a better job with the insulation around the heater block, but since the cartridge leads come out the side it was a little awkward so I just went with a single piece on top.
Hope it is useful to someone. I printed this in clear PET+. Incidentally, since I print exclusively in PET+ which does not use cooling on the print, the fan just cools the hotend only.