Pocket Oscilloscope Desk Stand

Instead of having your handy dandy pocket-sized oscilloscope sitting in hazardous sites of your work area, while it's not in use, perch it up on its own stand and benefit from the advantage of having it at the ready when you need it, where you need it. The housing has a hole through the middle of it, for the probe (now you'll never have to disconnect it from the oscilloscope so as to find it only when you decide to give up on using it altogether) to sit comfortably in and a small pocket at the back for placing the tiny accessories that come with the oscilloscope. The cutaway allows for access to the On/Off switch, the charging jack, and the probe jack.

The design is fully parametric so you can customize it to your delight, but beware: the code is neither tidy nor pretty and I will not be held liable for the damage it may cause to potential victims; that is to say I'm not 'fluent' in OpenSCAD just yet so do expect misdoings here and there in terms of the stand's 'parametricness'.

The provided STL works for the Velleman HPS140/HPS140i Oscilloscope. Yes, it has been tested successfully.