Summary

This version of the IKEA Dioder LED strip mount uses a clamp to fit on the ultimaker wooden parts. A long and short version for the left-right and the front side can be used.

Also a tulle is included for the power cable

Instructions

Print 4 times the short version for the left-right side and 2 times the long version for the front. Because I have the Ultimaker handle I cannot mount a LED strip at the rear side.

I used 100% infill for printing.

Interconnect the LED bars with the short cable. Drill a 8 mm hole at the left rear.
Feed the Ikea power cable from the top through the 8 mm hole, behind the Y-stepper motor through the cable duct. You need to feed the small white connector to the bottom and leave the big transparant connector at the top. Then put the tulle over the power cable and close the hole.
I am using the standard Ikea power adapter.

Partly based on the design of Johan van 't Hull (ID 32373)

Ikea Dioder LED strip on Ultimaker