Summary

A simple, no-support printable spoolholder for miniFactory 3D printer.

Instructions

This Spool holder consists of 2 parts, and is attachable (and removable, and re-attachable... :D) without any screws or tools. Just push the spool holder through the hole in miniFactory's upper right corner, and push the holder pin through the spool holder axis to lock it in place.
It holds most of the spools, smaller and bigger ones. It has very little friction so the spool runs smoothly on it. It's also located so, that the filament will run from it into feeder without any extra parts, even when making higher prints.

UPDATE:
There's now a shorter version of the Spool Holder, that works better with spools that have thinner edge. Also, The lock-part has been enhanced so, that you can use the spool holder on either side of miniFactory 3D printer - or Both, if that's what you want :)

A Spool holder for miniFactory