wire harness for shapeoko 2 stepper motor wires

The stepper motor wires that run from the X-axis bracket to the Y-axis bracket need to be kept from drooping down onto the workspace or into the gantry as the tool moves across the beam.
These two parts keep the wires neatly out of the way and allow easy tension control.

A couple of the images are rotated 90 degrees and the top image was cropped in the main view so the Y bracket is cut off, but you can see the full image if you click on it to open the viewer. Don't know why the images are rotated, as they are upright in my gallery, but I am unable to get them to upload in the correct orientation. Hope that is not too confusing. You can see the images displaying correctly on the shapeoko forum:
http://www.shapeoko.com/forum/viewtopic.php?f=11&t=3899