Summary

For holding and counting Chilean coins.
Para organizar y cuentar monedas Chilenos.

Instructions

Warning: this model is taller than 100mm. You may encounter bad mojo if your printer cannot print higher than 100mm.

The design was made for reprap, so I had to enlarge the small coin tubes to fit properly. Higher-res printers may print the holes too big but the coins should still not fall out. Each tube should hold 50 of each coin.
Built in 3dsMax.

Imprimir y disfrutar :)
Hecho para Reprap, puede ser que los tubos de las monedas chicas son un poco grande. Entonces, cada tubo tienen capacidad para 50 monedas de cada tipo.

Chile coin organizer/counter -- monedas de Chile