Summary

This is an interpretation of the official Silhouette cameo pen holder. There are two pieces that screw together in a similar way to the official one, however this one has been specifically designed to work with sharpie ultra fine point pens. Enjoy.

Print Settings

Printer:

any cubic i3 mega s

                                            <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.2</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>100%</p></div></p>                                                    <strong>Filament:</strong> sunlu PLA+                grey                    <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Increase the scale of the pen holder by 2-3% in the x and y directions only as the thread shrinks and is tight.  You may need to experiment to get the optimum setting for your printer and material combination.  I found that 2% scale increase gave a close but successful thread.  I had to go around the edges of the thread with a sharp craft knife to clean away the loose material to help the thread start without destroying it.    The overall body design has been created undersize to take account of the increased diameter resulting from the increase in scale but it may require a little fettling with some sand paper if it is tight in the tool holder.  DON'T change the Z scale.</p></div>

How I Designed This

Silhouette Cameo 3 Pen holder