Summary

A case for the Arduboy handheld – now with 66.6% more därkness.

The two-tone printing on the back involves slight trickery (see "print settings" below).

Print Settings

Supports:

No

                                            <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.1mm</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>100%</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>The writing on the back part of the case requires you to print the white letters, then change the filament and printing the black case over the top of it.  (Unless you have a dual extruder)</p><p>The STL files have little dots at the corners so that they have the exact same dimensions.  This should mean that your slicing software will open them in exactly the same position on the bed, which is important.</p><ol><li>load white filament</li><li>print GothBoy_white_parts.stl with <strong>no brim / raft / support / etc</strong></li><li><strong>don't</strong> remove the print</li><li>if possible, set your print bed to remain heated</li><li>load the black filament</li><li>print GothBoy_black_parts.stl</li></ol></div>

GothBoy case mod for Arduboy