Summary

Original design idea by Mohamad Koubar.

Print with 0.8 to 1.2mm nozzles.

Print Settings

Rafts:

Doesn't Matter

                                            <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>No</p></div></p>                                                                    <strong>Filament:</strong> - PLA                    <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Heated bed : 60°C - Speed : 40mm/s - 1 wall - No bottom - No top - After printing, put a 15cm long piece in between the ends of the print. Let cool down for 5 min. The print will then larger than before. This will alow more comfort for the user while still putting some pressure on the head.</p><p>If you want more or less pressure on the head, then simply use a smaller or a longer piece.</p></div>

Post-Printing

If your first layer has been crushed on the bed and therefore comes a bit out of the print, it can be quite discomfortable when wore. I would advise tu run a blade - or even your spatula- along the inner part of the print (the one that will go on the forehead). Do not try to cut like you normaly would, instead, use it like you would use a card scrapper.

Covid-19 shield eMotion Tech with fittings - 1mm nozzle