Summary

This is a printable flat bar/hand rail/grind bar for fingerboards (small skateboard toys, for example Tech Deck)

Print Settings

Printer:

Clone of a clone of a Prusa i3

                                            <p class="detail-setting rafts"><strong>Rafts: </strong>                     <div><p>No</p></div></p>                                                                                <p class="detail-setting supports"><strong>Supports: </strong>                     <div><p>Yes</p></div></p>                                                                                <p class="detail-setting resolution"><strong>Resolution: </strong>                     <div><p>0.2mm</p></div></p>                                                                                <p class="detail-setting infill"><strong>Infill: </strong>                     <div><p>30%</p></div></p>                                                        <br>                        <p class="detail-setting notes"><strong>Notes: </strong>                    </p><div><p>Print 3 copies of the foot, to attach to the legs. There is a 0.2mm difference, which locks together fine with my printer (which has far too much z-wobble, but that's a problem for later :-p ) - you may want to use a dab of superglue if this is too loose.</p><p>You may want to increase the infill if you are heavy-handed when locking in!</p></div>

Post-Printing

Stability

            <div><p>Obviously, PLA may just slide across your table when you hit a grind... I have a few tips</p><p>-Bluetack - put some bluetack on the feet to keep it fixed to the table/whatever hyou are skating on<br>-Middle foot - turn the middle foot by 90%, then you can have that leg between a couple of fingers on your spare hand, keeping it in place<br>-Drill - for something more permanent, you can drill it into your skatepark - you could also remix the foot piece to have some "bolt holes"</p></div>

Fingerboard Flat Bar/Handrail (Tech Deck)